The slurry pumps and other products listed below are applied in zinc and nickel.
Next
LCC-M Slurry Pumps
|
The LCC-M Series Slurry Pump is a hard metal, horizontal, end-suction, centrifugal slurry pump. The hydraulic wet end consists of three components: a shell or casing, an impeller that screws onto the shaft and a suction plate/liner to permit easy assembly and disassembly for maintenance and inspections. |
LCC-R Slurry Pumps
|
The LCC Rubber-Lined Series features a split-casing design with molded, replaceable rubber liners. The molded liner may be specified in a variety of natural and synthetic rubbers. Natural gum rubber is standard. The liners offer a shore-A hardness of 30-40 with a tensile strength minimum of 2,700 psi (18 n/mm2). |
LCV Slurry Pumps
|
GIW heavy-duty vertical slurry pumps are the answer for the most aggressive corrosive and abrasive slurry applications. |
LSA-S Slurry Pumps
|
LSA-S Series Slurry Pumps are designed for severe duties with operating flows from 100 gallons per minute (20 cubic meters per hour) to more than 60,000 gallons per minute (14.000 cubic meters per hour). These high-performance, low-maintenance slurry pumps are applied primarily in ore transport, mill discharge, cyclone feed, tailings and plant process. |
LSR Slurry Pumps
|
LSR rubber-lined extra heavy-duty slurry pumps are designed for hard-wearing applications. Operating flows to more than 40,000 gallons per minute (9000 m3h). |
Next
